FCG Motor - In February, we learned that the Dayton 2Z806 gear motor commonly used for to power the famous Flying Crank Ghost was discontinued.
Monster Guts searched for a suitable replacement, and we found one. It is very comparable to the Dayton, but in many ways, superior. More torque, more horsepower and a lower cost.
Quick Connect - This handy little device eliminates the hassle of connecting power supplies to wiper motors. Normally, to power a wiper
motor with a power supply would require the following steps: Step 1) Cut open the housing on the wiper motor to reach the terminals. Step 2) Snip off the end of the power supply. Step 3) Separate the wires of the newly cut power supply. Step 4) Strip the wires. Step 5) Solder the wires to the wiper motor terminals.
It takes two easy steps with the Quick Connect to power your wiper motor:
Step 1) Plug the Quick Connect into the wiper motor.
Step 2) Plug the power supply into the Quick Connect. That's it! Plug the power supply into a 110 VAC wall outlet and your done.
The Quick Connect is currently in production and will be available May, 2007.
I-Zombie Lightning Simulator - Every so often a product comes onto the market that makes us say WOW! The Lightning Simulator by i-Zombie Productions is such a product. We feel no other simulator on the market can match i-Zombie's effect, performance and price. With three different controllers to choose from, you're sure to find one that fits your need and budget.
Pressure Mats - we now carry these useful trigger mechanisms. Pressure mats allow a haunter to not only control where and when a prop will be triggered by a visitor's footsteps, but these sleek, black designs are near undetectable on darker floors in low light settings. We offer three sizes: 9"x16", 6"x23" and 14"x23".
http://www.MonsterGuts.com/
